Home Products drill bushings

Headless Liner Bushings

http://www.bonehamusa.com/wp-content/uploads/2013/02/Boneham-Product-Photographs-007-wpcf_400x266.jpg

Key Features:

  • ANSI Bushings
  • OD Ground to Press Fit Size
  • Special Sizes Available
  • Nitralloy (Nitrided) Bushings Available
  • Tight Tolerances, Heat-treated and Ground Finish

 

WHEN ORDERING STATE: Quantity, Symbol, Bore Size and whether its for a Drill or Reamer

Description:

Headless Liner Bushings

This range of drill bushings are for use in conjunction with renewable fixed and slip type bushings

The headless liner bushing: is permanently pressed into a drill jig or fixture plate. They provide a highly accurate location sleeve whilst eradicating wear caused by drill bushing replacement on the jig plate.

This range of drill / jig bushings is similar to the P range. This type of drill bushing is normally used for jigs where an economically priced drill bushing is required, or where less space is available on the jig plate. Headless liner bushings are pressed into the plate to achieve a flush surface in conjunction with a simple drilling and reaming operation. Headless drill bushings have less resistance than the headed type when subjected to large axial loads.These bushes are denominated by the L reference. All our drill bushings are hardened and have a ground finish to a press fit size.